Filter
Top Products
BEVEL CROSSCUTTING
Bevel crosscutting (Fig.68) is the same as crosscutting except the bevel angle is set to an angle other than 0°.
When possible, use the right miter gauge slot when bevel crosscutting so that the blade tilts away from
the miter gauge and your hands.
Use caution when starting the cut to prevent binding of the guard against the workpiece.
COMPOUND MITERING
Compound Mitering (Fig. 69) is a combination of bevel crosscutting and mitering, where the blade is beveled to an angle other than
0° and the miter gauge is locked at an angle other than 0 degrees. Always use the miter slot (D) which allows the blade to tilt away
from the miter gauge and hands.
D
26
RIPPING
MITERING
Mitering (Fig. 67) is the same as crosscutting except the miter gauge (C) is locked at an angle other than 0°. Hold the workpiece
firmly against the miter gauge and feed the work slowly into the blade to prevent the workpiece from moving.
Use caution when starting the cut to prevent
binding of the guard against the workpiece. Miter angles
greater than 45° may force the guard into the saw blade
and damage the guard. Before starting the motor, test
the operation by feeding the workpiece into the guard. If
the guard contacts the blade, place the workpiece under
the guard, not touching the blade, before starting the
motor. Certain workpiece shapes, such as mouldings,
may not lift the guard properly. Feed the work slowly to
start the cut.
C
Ripping (Fig. 70) is cutting lengthwise through a board. The rip fence (A) is used to position and guide the work. One edge
of the work rides against the rip fence while the flat side of the board rests on the table.
You must use the saw blade guard. On Delta saws, the guard has anti-kickback pawls to prevent
kickback, and a splitter to prevent the wood kerf from closing and binding the blade. Be sure to replace or sharpen
the anti-kickback devices when the points become dull.
Always use a rip fence for ripping operations. NEVER perform a ripping operation free-hand. Always
lock the fence to the rail.
The workpiece must have a straight edge against the fence, and must not be warped, twisted or bowed.
Fig. 67
Fig. 68 Fig. 69