Filter
Top Products
• Use the wire included in the kit or a small paper
clip to free the foreign rcatedals clogging or
restrictingthe nozzle.
Insert wire into nozzle and turn back and forth to
clear obstruction.
Remove additional debris by back flushingwater
supply through wand. Back flush between _ to 60
seconds. Turn wand to stream spray and mbve
nozzle from low to high pressure while flushing.
• "Reinstall nozzle into wand. DO NOT overtighten.
• Reconnect wand extension to spray gun.
• Reconnect the water supply, turn O1_1the water,
and start the engine.
• Test the cleaning system by operating with nozzle
in the high and the low pressure positions.
O-Ring Maintenance
Through the normal operation of your cleaning
system, the o-rings keep the connections of the hoses
and gun tight and leak-free. They may become worn
or damaged with use. Provided with your cleaning
system is an O---ring Maintenance Kit containing
replacement o-dngs, a rubber washer and a garden
hose inlet screen.
Parts in the O-Ring Kit Include:
1 o-dng, red, (pin B2726) for the end of the spray
gun connection between gun and high/low spray
wand.
• 2 o-rings, yellow, (p/n B2264) for the ends of the
high pressure hose.
Note: The above two o-dngs are close in size.
Please match carefully to assure proper o--dng
usage.
• 1 rubber washer (pin B2385) for the inside of the
garden hose connector.
• 1 water inlet screen (p/n B2384) for the garden
hose connector.
To remove a worn or damagedO-Ring:
• Use a small flathead screwdriver to get
underneath the o-ring and pry it off.
11