Filter
Top Products
.
.
Pull back collar on quick-connect and pull current
spray tip off. Store spray tips in holder provided on
the nozzle extension.
Select desired spray tip:
• For gentle rinse, select white 40° spray tip.
• To scour surface, select yellow 15° or red 0°
spray tip.
• To apply chemical, select black spray tip.
Low Pressure
Black
Use to apply
chemical
High Pressure
////
40 ° White 15° Yellow 0° Red
Usage Tips
• Pull back on collar, insert new spray tip and
release collar. Tug on spray tip to make sure it is
securely in place.
• For most effective cleaning, keep spray tip from
8 to 24 inches away from cleaning surface. If you
get spray tip too close, you may damage cleaning
surface.
• DO NOT get closer than 6 inches when cleaning
tires.
Cleaning and Applying Chemical
IMPORTANT: Use chemicals designed specifically
for pressure washers. Household detergents could
damage the pump.
CAUTION
.
2.
.
Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
Damage to equipment resulting from failure to follow this
instruction will void warranty,
Review spray tip use.
Prepare detergent solution as required by
manufacturer.
Place filter end of detergent siphoning tube into
detergent container.
CAUTION
When inserting the filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently
contacting the hot muffler.
4. Make sure black spray tip is installed.
NOTE: Detergent cannot be applied with the high
pressure spray tips (White, Yellow, or Red).
5. Make sure garden hose is connected to water
inlet. Check that high pressure hose is connected
to spray gun and pump and start engine.
6. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward,
using long, even, overlapping strokes.
7. Allow detergent to soak in between 3-5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow
detergent to dry on (prevents streaking).
IMPORTANT: You must flush the chemical injection
system after each use by placing the filter into a
bucket of clean water, then run the pressure washer in
low pressure for 1-2 minutes.
10