Filter
Top Products
DO NOT FILL THE FUEL TANK WITH GASOLINE THAT DOES NOT HAVE OIL MIXED IN IT.
SHAKE THE GASOLINE CONTAINER BEFORE EACH FILLING OF THE FUEL TANK.
011
(1/2 cup or 3.2 o7.) Shake Can
1 U.S. gallon container _-
• Pour 1 U.S. quart of fresh, clean,
unleaded automotive gasoline to a gallon
gasoline container.
• Add 3.2 oz of clean, high quality,
Craftsman two-cycle oil into the gasoline
container (One 3.2 ounces of oil pro-
vided).
IMPORTANT: Do not use outboard motor
oil or automobile oils, such as SAE 30 oil,
or multi-viscosity oils, such as 10W-30 or
10W-40.
• Reinstall the cap on the gasoline con-
tainer and shake container vigorously so
the oilmixes with the gasoline
• Add an additional 3 U.S. quarts of
gasoline to the gallon container and
shake the container again.
WARNING: Gasoline is flammable and cau-
tion must be used when handling or storing
it. Do not fill fuel tank while snow thrower is
running, hot, or when snow thrower is in an
enclosed area. Keep away from open
flame, electrical spark, and do notsmoke
while filling the fuel tank. Never fill fuel tank
completely; but fill the tank to within 1/4-1/2
inch from the top to provide space for ex-
pansion of fuel. Always fill fuel tank out-
doors and use a funnel or spout to prevent
spilling. Make sure to wipe up any spilled
fuel before starting the engine. Store gaso-
line in a clean, approved container, and
keep the cap in place on the container.
Keep gasoline in a cool, well ventilated
place; never in the house. Never buy more
than a 30 day supply of gasoline to ensure
volatility. Gasoline is intended to be used as
a fuel for internal combustion engines;
therefore, do not use gasoline for any other
purpose. Since many children like the smell
of gasoline, keep it out oftheir reach be-
cause the fumes are dangerous to inhale,
as well as being explosive.
4-
1 U.S.
gallon fuel
mix
TO STOP ENGINE
• To stop the engine, turn the key to OFF
and remove key, Keep key in a safe
place. The engine will not start without the
key, See figure on next page.
TO START ENGINE (ELECTRIC
START)
The snow thrower engine is equipped with a
120 volt AC electric starter and recoil starter.
Before starting the engine, be certain that
you have read the following information:
COLD START
• Insert the key and turn ON.
• Move the choke control to the FULL
position.
• Connect the power cordto the switch box
on the snow thrower.
• Plug the other end ofthe power cord into
a three hole, grounded 120 volt AC
receptacle.
• Push the primer button while covering the
vent holes as follows: (Remove finger
from primer button between primes).
Do not prime if temperature isabove
50°F.
Two times if temperature is 50" F to 15°F.
Four times iftemperature is below 15°F.
• Push down on the starter button untilthe
engine starts. Do not crank for more than
20 seconds at a time. This electric starter
is notthermally protected. Allow starter to
cool off for 10 minutes before starting
again or electric starter damaged can
Occur.
• Disconnect the power cord from the
receptacle first and then from the switch
box on the snow thrower.
• When the engine starts, release the
starter button and move choke lever to