Filter
Top Products
15
Servicing Blade
To Remove Blade
• Remove the bolt and blade bell support which
hold the blade and adapter to the engine
crankshaft. See Figure 16.
• Remove the blade and adapter from the
crankshaft.
To Replace Blade:
• Before reinstalling the blade and the blade
adapter to the unit, lubricate the engine
crankshaft and the inner surface of the blade
adapter with light oil.
• Install the blade adapter on the crankshaft with
the “star” away from the engine. See Figure 16.
Figure 16
• Place the new blade with the side marked
bottom (or with part number) facing away from
the adapter.
• Place the bell support next. Make sure to align
the tabs in the holes of the blade with the hole in
the bell support.
• Insert the hex bolt through the blade assembly.
Figure 16 shows the correct order of assembly.
• Use block of wood to hold blade again while you
tighten the bolt clockwise. Follow the
recommended torque for the bolt which is 450-
600 in.-lbs.
IMPORTANT: The bolt, used to secure the blade to
the engine, is specially heat-treated. Do not
substitute. To order replacement bolt, refer to the
Repair Parts section of this manual.
WARNING: To ensure safe operation of
your unit, all nuts and bolts must be
checked periodically for correct tightness.
Blade Adapter
Blade Bell
Support
Hex Bolt
Blade
Crankshaft
To Sharpen Blade:
The blade can be sharpened with a file or on a grinding
wheel. Do not attempt to sharpen while on the mower.
• Follow the original angle of grind as a guide.
Make sure that each cutting edge receives an
equal amount of grinding to prevent an
unbalanced blade.
NOTE: An unbalanced blade will cause excessive
vibration when rotating at high speeds, may cause
damage to the mower and could break, causing
personal injury.
• Test the blade by balancing it on a round shaft
screwdriver or a blade balancer. See Figure 17.
• If the blade is not balanced, remove metal from
the heavy side until it balances evenly.
Figure 17
Engine Adjustments
WARNING: Do not make unnecessary
adjustments on the engine. Factory settings
are satisfactory for most conditions.
If any adjustments are made to the engine
while the engine is running, keep clear of all
moving parts. Be careful of heated
surfaces and muffler. Keep your hands
away from these parts.
Carburetor
The carburetor has been pre-set at the factory and
should not require adjustment.
• If the engine on your mower does not operate
properly due to suspected carburetor problems,
take your lawn mower to your nearest SEARS
service center.
• Engine performance may be affected in altitudes
above 4000 feet. To improve engine
performance, install a high altitude adjustment
kit, available at the SEARS service center.
NOTE: A dirty air cleaner will cause an engine to run
rough. Be certain air cleaner is clean and attached to
the carburetor.
1. Insert screw driver through hole
2. Blade should be parallel to ground
Screw
Driver
Ground
Blade
SERVICE & ADJUSTMENTS
A
D
J
U
S
T
M
E
N
T
S