Filter
Top Products
40
2.
indicator
When the fixture head is adjusted to the desired angle, re-
an additional 10-degrees.
tighten end screws to secure the position.
Yoke arm indicator
Fixture head
1. To aim fixture, loosen both #10-32 x.625 end screws. When
the PointGrab
TM
system indicators are lined up, the slope
of the lens face is 40-degrees. Each subsequent notch is
#10-32 x 5/8
end screws
(by others)
1/4" Fasteners
Exploded view and part call-out
(by others)
#10-32 x1
Fixture head
End screw
Yoke end cap
fitting
(x3)
Socket cap screw
#6-32 x 5/8
Socket cap screw
(x2)
Yoke
Outdoor J-box
#6-32 x 1/2
1/2" Compression
#6-32 x 1/4
Screw (x2)
Wiring and sealing outdoor fixture
Warning
Visor and Non-Visor
: Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
Do not
Sheet 1 of 2
mount fixtures vertically.
Installation Instructions
Vault
C-Scroll
Roundel
These installation instructions are valid with the above Ametrix styles.
1
3
2
Large, OUTDOOR
YR (30 1/2")
(Yoke mount, Remote ballast)
ADY071449 Rev A (ECN070295)
Yoke end cap
Yoke end cap
End screw (x2)
#10-32 x 5/8
fasteners (by others).
With fixture head and yoke end cap safely stored, secure
yoke to outdoor surface using four(4) appropriate 1/4"
Mounting yoke to outdoor surface
(by others) (x4)
1/4 Fasteners
1. To secure yoke to outdoor surface, the fixture head must be
removed. First, remove both #10-32 x 5/8 end screws.
2. Remove one #6-32 x 1/4 screw to remove yoke end cap and
fixture head. Place both fixture head and yoke end cap in a
safe place.
3.
#6-32 x 1/4
screw(x2)
Aiming the fixture
(x2)
1/2" Compression
Socket cap screw
#6-32 x 1/2
#6-32 x 5/8
fitting
Socket cap screw
(x3)
1. To seal fixture head, after installing lamp, all screws and
latches must be secured on door face. Holes above latches
receive the #6-32 x 1/2 socket cap screws. The center hole(s)
receive the longer #6-32 x 5/8 socket cap screw.
2. Slide 1/2" compression fitting down fixture head wire and
splice wit power feed, ensuring all connections are properly
matched. Seal 1/2" compression fitting to outdoor surface and
ensure a watertight seal.