Filter
Top Products
Page 14For technical questions, please call 1-800-444-3353.SKU 67561
TECHNICAL
SPECIFICATIONS
Engine Type 4 Stroke, OHV
Bore x Stroke 70 x 54mm
Compression Ratio 8.5:1
Displacement 208cc
Fuel
Type
91+ octane premium
unleaded gasoline
Capacity 4 Gallons
Engine Oil
Type
SAE 10W-30 above 32° F
SAE 5W-30 at 32° F or
below
Capacity 2/3 Quarts
Spark
Plug
Compatible
Types
NGK BP61S
Bosch W6DC
Champion N11YC
Gap 0.024~0.031”
Valve
Clearance
Intake 0.1mm
Exhaust 0.15mm
Speed 3600 RPM
SERVICING
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
STARTING:
Turn the Power Switch of the
equipment to its “OFF”
position, wait for the engine to
cool, and disconnect the
spark plug wire(s) before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT
SERIOUS INJURY
FROM EQUIPMENT FAILURE:
Do not use damaged
equipment. If abnormal noise,
vibration, or excess smoking
occurs, have the problem
corrected before further use.
Maintenance Procedures
Many maintenance procedures,
including those not detailed
in this manual, will need to
be performed by a qualied
technician for safety. If you
have any doubts about your
ability to safely service the
equipment or engine, have a
qualied technician service the
equipment instead.
Note: Warranty is void if proper
maintenance and servicing
procedures are not followed.
Engine Oil Change
CAUTION! Oil is very hot during
operation and can cause burns. Wait
for engine to cool before changing oil.
Place a drain pan (not included) 1.
underneath the crankcase’s drain
plug.
Remove the Drain Plug (1a) and, if 2.
possible, tilt the crankcase slightly to
help drain the oil out. Recycle used
oil.
If the Drain Plug Washer (2a) is 3.
damaged, replace with a new
Washer.
Re-install the Drain Plug and tighten 4.
it in place.
Rell the oil to the proper level 5.
following the instructions under the
Starting the Engine section.
Air Filter Element Maintenance
Wipe off the air cleaner cover.1.