Filter
Top Products
SKU 65588 For technical questions, please call 1-800-444-3353. Page 10
Figure 4
5.
to its “CHOKE” position (far right).
-
sition (far left) when starting a warm
engine. See Figure 4.
Grasp the Recoil Starter Handle (4), 6.
and pull slowly until resistance is felt.
While holding the handle, allow the
starter rope to rewind slowly. Then,
pull the Recoil starter handle with a
rapid, full arm stroke. Once again
while holding the handle, allow the
rope to rewind slowly. Repeat as
necessary, until the engine starts.
After the engine starts and warms up, 7.
“RUN” position.
IMPORTANT: Allow the engine to run 8.
at no load until warm (1-5 minutes)
after each start-up to allow the engine
to stabilize.
Break-in Period
Breaking-in the engine will help to 1.
ensure proper equipment and engine
operation, and will extend the en-
gine’s lifespan. The warranty is void
if the engine is not broken in properly.
break-in period.
2.
Do not apply a heavy electrical load
to the equipment.
Do not operate the engine at its
maximum speed, use the Economy
Control Switch (on Control Panel).
3.
Change the engine oil.
NOTE: Under normal operating
conditions subsequent mainte-
nance follows the schedule ex-
plained in the MAINTENANCE AND
SERVICING section.
EQUIPMENT OPERATION
Follow correct starting and break-in 1.
procedures in previous section.
NOTE: Avoid connecting the Generator
to commercial power outlets. Avoid
connecting the Generator in parallel
with any other generators.
Plug in AC power cord from the item 2.
needing power. Always plug in larg-
To save power and gasoline, turn on 3.
the Economy Control Switch. If the
Generator sounds like it is faultering,
or lugging under it’s electrical load,
turn off the Economy Control Switch.
4.
unplug all electrical cords.
To prevent accidents, turn off the 5.
engine and disconnect its spark plug
wire after use. Wait for the engine to
cool, clean external parts with clean
cloth, then store the equipment out