Filter
Top Products
7
VER RAZANO
™
CANOPY HATCH INSTALLATION
Step 7. Tuck the wires into the canopy
with the wire nuts pointed upwards, so
that the WHITE and BLACK wires are on
opposite sides of the canopy and all wires
are clear of the canopy opening.
Step 8. Install canopy hatch with the
last canopy screw and lock washer. To
do this, tilt the fan body away from the
hatch opening. Tighten the screws fi rmly
by hand only.
Step 9. Straighten the fan, then check
to ensure that there is no movement be-
tween the canopy and ceiling or Hang-Tru
ball and top support shaft.
TILT THE
FAN TO
INSTALL
LAST
CANOPY
SCREW
CANOPY
HATCH
CANOPY
SCREW
LOCK
WASHER
Note: Write down the Se-
rial Number and the model
number on the inside front
cover of this manualfor
future reference.
1. Remove the screws and switch plate from the existing
switch box.
2. Remove the screws holding the switch in the switch
box.
3. Pull the existing switch from the switch box to expose
the wire connections.
4. Remove the three wires from the switch.
5. Wiring preparation, if required:
Strip wires:
• 3/8” for 14 guage
• 1/2” for 16 and 18 guage
NOTE: The wire connectors provided are suitable for
copper wire only. Use to join the following wire combina-
tions: One No. 14 gauge with one No. 16 or 18 gauge
6. Connect BLACK lead of control to 120V AC hot wire.
Connect the RED lead to the light circuit controlled by
slider on right side of unit. Connect YELLOW lead to fan
motor(s) wire. The fan speed will be controlled by the
left slider on the unit. If unit is used to control only one
light circuit, place wire connector on unused lead. Secure
these connections with the wire connectors.
7. Install the W-18 / W-28 in the wall box with the two long
screws provided.
CAUTION: Be sure no wires are pinched!
8. Install the wall plate with the two color matched screws.
9. Turn on power to test the controller.
INSTALLATION OF WALL CONTROL
Step 6b. The W-18 / W-28 is designed to replace a standard
wall switch and will fi t wall boxes (metal or plastic) with
a depth of 2” or greater.
3/8” or 1/2”
CAUTION: Ensure power is turned OFF at
the breaker or fuse panel before start-
ing installation.