Casablanca Fan Company 63XXT Outdoor Ceiling Fan User Manual


  Open as PDF
of 11
 
5
Vi c t o r i a n
®
Step 3. To hang the fan body in the
canopy, hold the fan body firmly and
insert the ball into the canopy open-
ing. Check that no wires were pinched.
Rotate the fan body until the slot in the
nylon ball fits into the pin opposite the
canopy opening.
HANGING THE FAN
NOTE: Independent control of the
light fixture using a W-80 requires
an additional power wire run from
the wall switch to the fan. See Page
11 for wiring.

BLUE

WIRE ON



CONTROL
SLOT
BALL

CANOPY ELECTRICAL CONNECTIONS
Step 4a.Attachthefanwirestotheceilingxtureoutlet
boxwiringbytwistingthebareendsofthewirestogether
and then securing with a wire nut. Test that the connection
is secure by pulling on the wire nut. Connect in this order:

• GREENleads frommountingplateandfan toGROUND
conductor of power source. Secure with wire nut.
• WHITEwirefromfantowhiteNEUTRALwireinceiling
xtureoutletbox.Securewithwirenut.
• BLUEwireandBLACKpowerwirefromfantoBLACKpower
wireinceilingoutletbox.Securewithwirenut.

• GREENleads frommountingplateandfan toGROUND
conductor of power source. Secure with wire nut.
• WHITEwirefromfantowhiteNEUTRALwireinceiling
xtureoutletbox.Securewithwirenut.
• BLACKpowerwirefromfantoREDwirefromW-80inceil-
ingoutletbox.Securewithwirenut.
• BLUEwirefromfantoYELLOWwirefromW-80inceiling
outletbox.Securewithwirenut.

2 BLACK & BLUE


WIRE NUT

3 GREEN WIRES
3 GREEN WIRES

BLACK & RED
WIRES
BLUE & YELLOW
WIRES


CANOPY HATCH INSTALLATION
Step 5. Tuck the wires into the canopy
with the wire nuts pointed upwards, so
thattheWHITEandBLACKwiresareon
opposite sides of the canopy and all wires
are clear of the canopy opening.
 Install canopy hatch with the
last canopy screw and lock washer. To
do this, tilt the fan body away from the
hatch opening.
Tighten the screws firmly by hand only,

FAN TO
INSTALL
LAST

SCREW



SCREW
LOCK

Step 7. Straighten the fan, then check
toensurethatthereisnomovementbe-
tween the canopy and ceiling or Hang-Tru
ball and top support shaft.
 previous next