Casablanca Fan Company 63XXT Outdoor Ceiling Fan User Manual


  Open as PDF
of 11
 
3
Vi c t o r i a n
®
MOTOR



MOTOR
WIRES
GROUND
WIRE
ALLEN
SET SCREW
DOWNROD
& BALL
ASSEMBLY
INSTALLATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan,
removeallpartsfromtheshippingcartonsandcheckthem
against the parts listed here. Before discarding packaging
material,becertainthatallpartshavebeenremoved.
CEILING HARDWARE
CROSSBAR MOUNT
ING BRACKET
WIRE NUT (4)
FAN PREPARATION
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box
Ifyoudonothaveanexistingxturelocatedwhereyouwish
toplaceyourCasablancafan,anapprovedceilingxture
outletboxmustbeinstalledandwired.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit
breakerorfusebox),lowertheoldxtureanddisconnect
thewiring.Checktheceilingxtureoutletboxtobesure
thatitismarked‘Approved for ceiling fan mounting’.Ifitis
not,anewboxmustbeinstalled.

Step A. Route the wires from the motor through the
Perma
•
Lock™downrodandballassembly.
Step B.Usingtheprovidedallenwrench,loosenthesetscrew
severalturnstoallowinstallationofthedownrod.Threadthe
downrod into the motor coupling until it stops turning, this
will take at least four and a half full turns.
Step C.Securelytightenthesetscrewwiththeprovidedallen
wrench to ensure safe operation of your fan.
Tip: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
CAUTION: Failure to fully lock in the down
rod before securely tightening the set screw
may cause the fan to separate from the
downrod during normal operation!
IMPORTANT SAFETY INFORMATION!


NOTE: Only one set of blade holders is supplied. Depend-
ing on the fan model and series they will be either the
Commodore Style, the Center Style, the Badge Style with
matching badges, or the Standard Style blade holder.
Warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked ac-
ceptable for ceiling fan support using the mounting
hardware provided with the outlet box.
ADDITIONAL HARDWARE
2
1
/
4
″ x
SCREWS (2)

1″ x

DOWNROD & BALL
ASSEMBLY
PERMA
•
LOCK™ HARDWARE
ALLEN SET SCREW
1
⁄
4
x
1
⁄
4
”

3mm

 previous next