Casablanca Fan Company 63XXT Outdoor Ceiling Fan User Manual


  Open as PDF
of 11
 
10
Inteli•Touch
®
Before Requesting Service: Please follow this troubleshooting guide be-
fore contacting your dealer for assistance.
Caring for Finishes: For cleaning, a soft brush or lint-free cloth
shouldbeusedtopreventscratchingthenish.Avacuumcleaner
brushnozzlecanremoveheavierdust.Surfacesmudgesoranac-
cumulationofdirtanddustcaneasilyberemovedbyusingamild
detergent and slightly dampened soft cloth. An antistatic agent
may be used, but neveruseabrasivecleaningagents.Thesewill
damage the finish. Painted and high-gloss blades may be cleaned
in the same manner.
Blades: Wood finish blades should be cleaned with a furniture
polishing cloth. Occasionally, a light coat of furniture polish may
be applied for added protection and beauty.
Never Lubricate this Fan!
The precision motor at the heart of your Casablanca fan features
sealed bearings that are lubricated for life. Do not attempt to oil
the motor.
Changing Light Bulbs
Be sure to turn power to the fan OFF at the wall switch or circuit
breaker before changing light bulbs. Replace bulbs with same type as
removedfromthexture.Eachfanisratedfora maximumTOTAL
wattage of lighting.
Exceedingtheratedmaximumallowablewattageforthefanwill
burnoutthefanelectronicsmoduleandvoidthewarranty.
NO FAN OR LIGHT Check main circuit fuses, curcuit breakers, or wall switch position. Check all wire connections, making
sure the power is turned off during this inspection.
FAN WOBBLES OR SHAKES Be sure canopy pin is properly set into the slot on the ball
EXCESSIVELY Check the screws holding the blade holders to the fan motor. Tighten as necessary.
Check the angle of the blades to make sure that a blade holder has not been bent during installation.
FAN NOISY DURING Checkandtightenlightxtureretainingscrews,glassshadescrewsand/orthelightbulb(s).
OPERATION Tighten canopy screws and mounting plate assembly.
Tightenthebladetobladeholderscrewsandbladeholderstoywheel.
Makesureallscrewsinthemotorhousingaresnug,butnotoverlytight.
Check that the wire nuts inside the canopy and switch housing are not touching the metal parts or
havefallenoffthewiresplices.Tightenoradjustasnecessary.
BREAK-IN PERIOD Letfanrunathighspeedfortwo(2)hours
DOES NOT RUN ON Ifnew,“break-in”mayberequired-runathigherspeedforseveraldays
LOW SPEED
LIGHTS FLASH OR BLINK DURING OPERATION OF W-32 WALL CONTROLS/FAN MAY ROTATE OR MAKE
AUDIBLE TONES DURING OPERATION OF THE W-32 WALL CONTROLS: Normal operation.
WHEN AC POWER IS TURNED ON FOR THE FIRST TIME, THE LIGHTS OPERATE NORMALLY, BUT W-32 WALL
CONTROL OPERATION IS REVERSED: FAN BUTTON OPERATES THE LIGHTS; LIGHT BUTTON OPERATES
THE FAN: Reversethe2blackandwhitestripedwireconnections.
FAN OR LIGHTS APPEAR TO OPERATE BY THEMSELVES (CHANGING SPEED OR INTENSITY), WALL CON-
TROL OPERATION IS INTERMITTENT: CheckACsupplyforirregularities,(noisespikes,uctuations,orfailure);orcircuit
board assembly.
PROBLEM POSSIBLE REMEDIES
TROUBLESHOOTING
INTELI•TOUCH
R
 previous