Filter
Top Products
Please find below an image depicting how to attach the red dot finderscope and an image
depicting a fully-attached unit.
How-To-Attach: Place Finderscope Cylindrical Groove over Cylindrical Finderscope Mount
Post until it clicks into place.
Aligning and Using Red Dot Finderscope
Remove plastic insert on bottom side of finderscope to allow battery to make connection with
battery contact for power. Turn power switch on.
Look through main telescope tube at low power and establish a well-defined stationary target.
Looking through red dot finderscope, alternate tightening each adjustment wheel (at rear and
left side of finderscope) until the red dot of finderscope is precisely aligned and centered on the
same object being viewed in main telescope tube.
Plastic Insert
Adjustment
Wheels