Filter
Top Products
45
Troubleshooting, Adjustment & Repair
Deck Leveling Adjustment
NOTE: Before adjusting the deck level, the deck lift
rod timing must be checked and/or adjusted.
Coarse Adjustment Procedure
When adjusting the deck level, the coarse adjustment
procedure should be used to make the majority of the
adjustment and the Fine Adustment Procedure should
be used to complete the adjustment.
1. Park machine on a flat, level surface. Disengage
the PTO, stop the engine and engage the parking
brake. Rear tires must be inflated to 18 psi (1,24
bar); front tires to 25 psi (1,72 bar).
2. Lock the deck lift pedal in the 5” (12,7cm) position.
Place the deck height adjustment pin in the 4”
position and lower deck the lift pedal until the arm
contacts the pin.
3. Place 2 x 4 blocks under each corner of the
mower deck with the 3-1/2” sides being vertical.
See Figure 47.
4. Adjust the front eyebolts until the chains are tight
and the deck is still resting on the 2 x 4’s. Tighten
the jam nuts. See Figure 48.
5. Loosen the nuts and allow the rear of the deck to
rest on the 2 x 4’s. Slide the chains down in the
slots until the chains are tight and tighten the nuts.
See Figure 48.
6. Remove all 2 x 4 blocks from under the mower
deck.
7. See Figure 49. Position the outside mower blades
so they face front-to-back.
8.
Measure from the front tip of the blade from the
cutting edge to the ground. Measure from the
rear tip of the blade from the cutting edge to the
ground. Repeat this process for the other side of
the machine.
• The measurements should be 4” (10,2 cm).
CAUTION
Avoid injury! Mower blades are sharp.
Always wear gloves when handling blades or
working near blades.
Figure 47. 2 X 4 Locations (Arrow points toward front
of the deck)
Figure 48. Hanger Chain Adjustment
A
A
A
Figure 49. Checking the Blade Height Adjustment
Not for
Reproduction