Filter
Top Products
19
ADVANCED DRIVING
Executing an End-Of-Row Zero Turn
Your Zero Turn Rider’s unique ability to turn
in place allows you to turn around at the end
of a cutting row, rather than having to stop
and Y-turn before starting a new row.
For example, to execute a left end-of row
zero turn:
1. Slow down at the end of the row.
2. Move the RIGHT ground speed control
lever forward slightly while moving the
LEFT ground speed control lever back to
center and then slightly back from center.
3. Begin mowing forward again.
This technique turns the rider LEFT and
slightly overlaps the row just cut eliminating
the need to back up and re-cut missed grass.
As you become more familiar and
experienced with operating the Zero Turn
rider. You will learn more maneuvers that
will make your mowing time easier and more
enjoyable.
Remember, the more you practice, the
better your control of the Zero Turn will
be!
Practice Turning Around a Corner
While traveling forward allow one handle to gradually
return back toward neutral. Repeat several times.
NOTE: To prevent pivoting directly on the tire tread,
it is best to keep both wheels going at least slightly
forward.
Figure 7. Turning Around a Corner
Figure 8. Turning in Place
Figure 9. Executing an End-Of-Row Turn
Practice Turning In Place
To turn in place, “Zero Turn,” gradually move one
ground speed control lever forward from neutral and
the other lever back from neutral simultaneously.
Repeat several times.
NOTE: Changing the amount each lever is pulled
forward or back, changes the “pivot point” you turn on.
Operation
Executing
Turns
Turning
In-Place
Not for
Reproduction