Briggs & Stratton RIDER 16 Lawn Mower User Manual


 
English 49
1
2
11
3
1
2
Reparation instructions
Adjusting cutting height area
Raise or lower the entire mowing deck by screwing
the nuts up or down.
If the highest cutting height is raised by 5 mm
(3/16") the other fixed cutting heights will also be
raised by the same amount.
Remove the right-hand fender.
Adjusting cutting height
Loosen the nuts on the height setting arm.
Adjust so that the distance between the stop for
the lowest height setting and the protective
frame is 5 mm (3/16").
Tighten the nuts.
Check that the parallelism has not changed. If it
has changed, the parallelism must be
readjusted again.
Check and adjust the cutting units ground
pressure as set out (see Checking and
adjusting cutting unit ground pressure) if
necessary.
Fit the nose.
IMPORTANT INFORMATION
The parallelism and height must be
adjusted again when changing the cutting
unit.