Filter
Top Products
44 – English
2
3
1
Reparation instructions
Bleeding the hydrostatic transmission
oil system
• Check the hydrostatic transmission oil level.
• Start the engine and set the throttle control to
idle.
• Repeat opening and closing the disengaged
clutch control whilst the front respective rear
pedals are alternately pressed down.
• When the mower starts to move set the governor
control lever to high idle.
3. Repeat quick starts and emergency stops until
the transmission responds as it should.
• Check also the oil level in the hydrostatic trans-
mission, and top up if necessary.
4. Check and top up with oil if necessary after test
driving.
• The neutral position is adjusted by turning the
hexagonal axle on the transmission (see dia-
gram).
• Start the engine and set the throttle control to full
throttle.
• Unscrew the hexagonal axle lock nut and turn
the axle clockwise until the drive shafts start to
rotate backwards.
• Make a mark on the top of the axle.
Adjustment of transmission neutral
position
1. Bleed the hydrostatic transmission oil system.
2. Lift the back of the ride-on mower up so that the
wheels are off the ground and place blocks
under the machine.