Briggs & Stratton RIDER 16 Lawn Mower User Manual


 
English 37
2
1
1
2
Removing/installation of hydrostatic
transmission Rider 13 H/13 H Bio and
Rider 16 H
Removal/installation of gear box
Rider 11
Block-up the machine in front of the rear frame
and dismantle the rear wheels.
Remove the cover from over the gear box.
Lower the garage jack and pull out the gear box.
Installation of the gear box is carried out in the
reverse removing gear box order
After installation, check that the clutch, brake
and gear wires are correctly adjusted (see
Checking and adjusting brake wire, Checking
and adjusting gear control and Checking and
adjusting freewheel clutch).
Release the tensioning wheel spring (1).
Unfasten the clutch wire (2), and detach the belt
from the gear box pulley.
Detach the gear and brake wires (3 and 4).
Insert a garage jack under the gear box and
unscrew the gear box's five holder screws (5).
3
Reparation instructions
Block-up the machine in front of the rear frame
and remove the back wheels.
Remove the transmission cover.
Release the tensioning wheel spring (1).
Remove the fan (2), it is held by a circlip.
Work off the drive belt (3).
Remove the oil tank (4).
Release the brake wire spring and remove the
brake wire from the brake lever (concealed under
the oil tank).
Release the hydrostatic transmission link (5) in
the front ball joint.
Remove the screw (6) holding the arm.
Remove the freewheel clutch control (7) with its
spring.