Briggs & Stratton RIDER 16 Lawn Mower User Manual


 
36 English
1
2
Attach a washer and circlip onto the swing axle
(1).
Firmly secure the wires' holder plates (2), as well
as the gear and brake wires (3 and 4).
Connect the belt onto the pulley and tightly screw
the tensioning wheel arm (5) onto the rear frame.
Attach the clutch wire (6) and the tensioning
wheel spring (7).
3 Rider 13 and 16
Fit the washer and circlip on the swing axle.
Fit the hydrostatic transmission wire and its
casing (2+4).
Fit the cable on the neutral position contact (5).
Fit the rear belt (8).
Fit the brake wire on the arm under the tank and
the casings holder on the rear frame (6).
Fit the tensioning wheel spring (1).
Fit the hydrostatic transmissions fan and the
circlip (7).
4 . Check that wires and controls are correctly
adjusted (see Inspection and adjusting of
respective wires). Finally, fit the cover on the
transmission/gearbox.
Check the setting of the neutral position switch
on machines with hydrostatic transmission, see
Electrical system\Microswitch neutral position.
3 Rider 11
Grease half of the axle (the half that has not
been turned down) and press it from the back
into the steering spindle (see diagram).
Attach the washer and circlip on the swing axle's
inner holder.
Fix the dust guard (with a thin lip behind) approx.
2/3 of the way in on the axle and lubricate the
axle on both sides of the dust guard.
Installation of swing axle
Roll the rear frame forwards and press it in on the
swing axle.
Reparation instructions