Briggs & Stratton RIDER 13 BIO Lawn Mower User Manual


 
40 English
3
2
1
3
Reparation instructions
Place the sealing collar on the axle, with the
metal spring inwards, and press it in
carefully
.
Use the narrow end of a 1/4" extender to
carefully
knock in the sealing collar until it
reaches the bottom of the axle housing. Only
knock on the steel cover.
Move the extender in a circle around the sealing
collar so that it is pressed in evenly all the way
around and tight against the axle.
Remove the insulation tape from the axle and
repeat, as is necessary, the entire procedure for
the second axle.
Replace the washer, spacing sleeve, key and
rear wheel on the axle. Fit the circlip that holds
the wheel and the plastic cover over the axle
end.
Fill the transmission's oil container with SAE
10W30 oil until the oil level reaches the "MAX"-
marking.
Bleed the transmission as directed in Bleeding
of the hydrostatic transmissions oil system.
Operate the ride-on mower and then check that
there is no oil leaking from the new axle sealing
collars.
Check the oil level and top up if necessary after
test running.
Remove the frame plate by undoing the screws
(two on each side).
Remove the hydrostatic transmission wires front
clamp fixed inside the middle bracket.
Loosen the hydrostatic transmissions front lock nut
a 1/4 turn and remove the lock spring.
Replacing hydrostatic transmission wire
Removal of hydrostatic transmission wire