Filter
Top Products
42 – English
2
1
5
4
3
Reparation instructions
Screw the front ball joint onto the new transmission
wire and tighten the lock nut.
Run the wire through the mower so that it follows
the same route as the old wire.
Refitting hydrostatic transmission wire
Press the wire casing in the front holder in the
middle bracket.
Screw tight the hydrostatic transmission wire’s
clamp. Press the linkage in its holder and fit the
lock spring.
Screw tight the linkage on the lower part of the
transmission wire. Screw 10-12 turns so that the
linkage has the correct length.