Arboria Heritage Arbor Patio Furniture User Manual


  Open as PDF
of 4
 
Heritage Arbor/Grand Entry
PLEASE READ THROUGH BEFORE STARTING ASSEMBLY
ASSEMBLY INSTRUCTIONS
HA
YOU WILL NEED
COMPONENTS LIST
Arbor side panels (2)
Headers (2)
Braces (4)
Caps (7)
Wings (2)
Post sleeves (2)
Post Base Kit (2)
Post caps (2)
(Hardware included)
1
2
3
4
5
6
Arbor only
• 2 1/2” screws (8)
• 3 1/2” screws (22)
• 9 7/8” spacer block
• Anchor stake kit
◊ 3/4” screws (8)
◊ Anchors (4)
PRELIMINARIES
IF YOU PLAN TO PAINT
If you wish to stain or paint your arbor/entry, we recommend that you do so before assembly, this will make the product
easier to install. Be careful not to cover up guide marks on the rafters.
WORK AREA
Select an area close to where the arbor/entry will be installed. The assembly area should be relatively flat and open with
at least 8’x6’ of space. We recommend the use of the shipping box as your work surface to protect the arbor/entry
against damage during assembly.
Complete
Assembly
Components 5-8
included with
Grand Entry Only
1
7
6
5
8
3
2
4
7
8
• 2 1/2” washer head screws (8)
• #2 square head driver bit
HARDWARE PROVIDED
445.35.100 1 of 4 9/29/2006
Division of LWO Corp. / P.O. Box 17125 / 3841 North Columbia Boulevard / Portland, Oregon
503-286-5372 / fax 503-286-4092
Additional Hardware
(Included with Grand Entry)
• 5’ Pressure treated 4x4
posts (2)
• 2” Galvanized trim head
nails
• Concrete mixing tools
• Wood shims
• Wood adhesive
• Pre-mix concrete (120lb)
Additional Tools and
Supplies for Grand Entry
Tools and Supplies
for Arbor
• Phillips screwdriver
• Tape measure
• Carpenter Square
• Pre-mix concrete (120lb)
(optional)
next