Filter
Top Products
9
Check transmission oil level after rst 5 hours of
operation. Remove oil ll plug (gure 10). Oil level must
be even with the plug hole (with tiller level). If necessary,
add oil. Use SAE 30 non-detergent motor oil. Replace oil
ll plug.
Check transmission oil level after each 10 hours of
operation.
it is not necessary to change the oil in this tiller
transmission. If for any reason it must be changed, oil
capacity is 22 oz.
Clean engine as instructed in the engine manual.•
Clean wheels, nish, etc. Of all foreign matter.•
Keep nished surfaces and wheels free of all •
gasoline, oil, etc.
Protect painted surfaces with automotive type wax.•
We do not recommend using a garden hose to clean
your unit unless the mufer, air lter and carburetor are
covered to keep water out. Water in engine can result in
shortened engine life.
MUFFLER
Do not operate tiller without mufer. Do not tamper with
exhaust system. Damaged mufers or spark arresters
could create a re hazard. Inspect periodically and
replace if necessary. If your engine is equipped with a
spark arrester screen assembly, remove every 50 hours
for cleaning and inspection. Replace if damaged.
FiGURE 10
FiGURE 11
Always stop engine and
disconnect spark plug wire before cleaning,
lubricating or before performing any repairs
or maintenance.
• Check before each use and every 8 hours.
• Maintain engine oil as instructed in gure 11 below.
• Service every 25 hours under normal
conditions. Clean every few hours under extremely
dusty conditions. Poor engine performance and
ooding usually indicates that the air cleaner should
be serviced. To service the air cleaner, refer to the
separate engine manual.
• replacement is recommended every 100
hours or yearly. Check the engine manual for correct
plug type and gap specications.
OIL
FULL OIL LEVEL
REMOVE OIL CAP
REPLACE CAP
AFTER FILLED