AeroGarden 100602-SLR Greenhouse Kit User Manual


 
Replace
Bulbs
24-Hour
Light
Add
Nutrients
Add
Nutrients
Replace
Bulbs
Locking Lever
Basic Reminders About Your AeroGarden (continued)
As plants grow to 1-2” from lights, raise the Lamp Arm one notch at
a time. Be sure Lamp Arm is set at the lowest setting when you start
your AeroGarden.
Unplug Space•Saver 6 and remove Bowl from Base.
Hold Lamp Arm where it connects to Lamp Hood with one hand.
With other hand, push in Locking Lever.
Release Locking Lever while pulling up on Lamp Arm.
Locking Lever will automatically click into next notch in Lamp Arm.
Replace Bowl on Base and plug in Space•Saver 6.
Note: When lowering Lamp Hood, be sure to hold Lamp Arm
to avoid crushing plants.
1
2
3
4
Raise Lamp Hood (Lights)
When “Replace Bulbs” light on Control Panel begins to
blink after 6 months of use…
• Unplug Space•Saver 6.
• Remove old Grow Bulbs and carefully discard*.
IMPORTANT: To avoid burning, be sure Grow Bulbs are cool before handling.
• Insert new Grow Bulbs into Lamp Hood.
• Plug in Space•Saver 6 and press and release “Reset”
button to restart grow bulb timer.
Early Grow Bulb Replacement
If you replace Grow Bulbs before “Replace Bulbs” light illuminates, be sure to
restart grow bulb timer as follows:
• Press and hold “Lights” button until white light next to your selected plant
type starts blinking – about 5 seconds.
• Release “Lights” button. Plant type selected light will continue to blink for
about 9 seconds. While plant light is still blinking…
• Quickly press and release “Reset” button. “Replace Bulbs” light will blink
once and plant selected light will stop blinking.
Replace Grow Bulbs – Order replacement bulbs at www.aerogardensupport.com
Space•Saver 6 Elite
Control Panel
Space•Saver 6
Control Panel
*Check with local recycling authorities for light
bulb recycling availability in your area.
12