-
Need Part
Problem posted by craigmonk@[email protected] on May 15, 2008
There is a aluminum cast part which spins as you pull the crank line. It has curved veins and some locking points so as to lock when you crain and let go when it starts. I need this cast part. Ican not find the name of it or the serial number. All I can tell you is that the family # is VPW…
-
Oil/ Fuel Mixture
Problem posted by jbates7619@[email protected] on May 15, 2008
What is the oil/fuel mixture ratio for this model. I have forgotten and lost my owners manual.
-
oilier
Problem posted by ace13733@[email protected] on May 14, 2008
i dont know how to adjust my oilier because im getting little to no oil to my bar and chain.
-
owners manual
Problem posted by raycourville@[email protected] on May 12, 2008
Need owners manual
-
Micro 25 Deluxe
Problem posted by jbwillis50@[email protected] on May 12, 2008
Gas cap & maintainence manual
-
Need Owner's Manual
Problem posted by rbirwin@[email protected] on May 11, 2008
Could someone please help me locate a manual for this chainsaw?
-
New chain installation
Problem posted by jasperlake@[email protected] on May 11, 2008
With difficulty removed drive cover and with new chain installed can't get cover back on....because of the spring clip circumference. What am I doing wrong?
-
age of saw
Problem posted by mrdice@[email protected] on May 6, 2008
I was hoping someone might be able to tell me the age of my Remington gas chainsaw... it has no spark, I also might need points and a coil... it also has never been started!!
thanks,Randy
-
Echo 452VL operator manual/service manual
Problem posted by johnlyn@[email protected] on May 5, 2008
recieved a chainsaw Echo 452VL. Cleaned unit up and put fresh gas in. I am able to turn unit over using starting fluid in carb. but not able to keep it going. I was wondering if anyone would have amanual explaining what all of the switches and dials are on this unit. I have a white lever…
-
replacement chains
Problem posted by mtn_trvlr@[email protected] on May 5, 2008
does anyone know what the actual Gauge and Pitch of the stock chain is? if I can order by that info, chains cost $14.00 avg. when using the "Poulan # their $21.50.
-
need repair manuals for these chain saws
Problem posted by northpol@[email protected] on May 1, 2008
having trouble with carbs