-
can't start
Problem posted by ccherepanya@[email protected] on May 10, 2008
Not getting spark to plugs and can't start engine
-
Manual
Problem posted by tripostar@[email protected] on May 10, 2008
Manual
-
need belt diagram
Problem posted by randycell@[email protected] on May 9, 2008
the mower belt came of and I need a picture or drawing of the correct belt path
-
starting problem
Problem posted by brianppotter@[email protected] on May 5, 2008
i suspect a safety overide switch is malfunctioning. the battery is new but nothing will happen when the key is turned on. no click, nothing. it is acting as if the pto is engaged. i replaced the pto switch to no avail. any ideas what it might be causing the provlem. the cilinoid can be jumped…
-
Blades won't engage
Problem posted by lisabrak@[email protected] on May 3, 2008
The blades will not engage. I have replaced to PTO swithc and the relay assembly and still not working. The pullys move freely and belt okay. The belt up high seems to be loose and the pully doesn't move. However this pully is not attached to the mower deck.
No loose wires although there…
-
rear end
Problem posted by loudon5@[email protected] on May 3, 2008
we changed the seal and the baaring in the pump at the end of the drive shaft and now it wont move its full of oil new filter everyhtings tight the freewheel switch is up and now i dont get it any answers
-
ignitiion switch
Problem posted by bradshawb2@[email protected] on May 3, 2008
the old switch is bad and I had to replace with new one and need wiring diagram
-
Lost Manual
Problem posted by ccherepanya@[email protected] on May 3, 2008
Lost Manual
-
how to change blades
Problem posted by blazzerboy@[email protected] on May 2, 2008
no manual need to know best way and how to change blades
-
operation manual
Problem posted by ansel41@[email protected] on May 1, 2008
Tractor came with house and it has no paperwork at all. I have been able to buy parts OK just can't seem to adjust the deck.
-
mower
Problem posted by dmanbluz@[email protected] on Apr 30, 2008
When the electric clutch is engaged the motor will die. All this happened after I mowed the lawn. When i went otput the mower in the shed, the starter would not engage and i had to jump the starter terminals to get it started. After getting it started, iengaged the mower clutch and that/s when…
-
type
Problem posted by mcalpinjo@[email protected] on Apr 29, 2008
what is my type