Comments On This Problem

• Jammed pully rope on ryobi trimmer
  Posted by lrl30 on May 21st, 2008 at 9:41pm
  
  
  use a torx screwdriver to loosen the screw in sidethe bell shaft to get to the rope pully
  
  
  Was this comment useful?
• Jammed pully rope on ryobi trimmer
  Posted by wmars1776 on May 22nd, 2008 at 9:04am
  
  
  I got the bell shaped part off with a torx driver. I am talking about the thick round part with two thick springs on it where the casing is underneath?
  
  
  Was this comment useful?
• removing the part under the bell
  Posted by lrl30 on May 22nd, 2008 at 8:21pm
  
  
  you can hold the shaft with a pair of vice grips and turn the partcounter clockwise and it should unscrewthen you can remove the plastic housing to get to the rope and pully.
  
  
  Was this comment useful?
• removing the part under the bell
  Posted by wmars1776 on May 23rd, 2008 at 9:39am
  
  
  Thanks - will give that a try.
  
  
  Was this comment useful?

Add Comment